GE Profile CustomStyle 22 Série Manuel D'utilisation Et D'installation page 33

Masquer les pouces Voir aussi pour Profile CustomStyle 22 Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problem
Cube dispenser (on some
models) does not work
Dispensed water
(on some models)
has poor taste/odor
Dispensed water
is warm
Water dispenser does
not work
Water is not dispensed
but icemaker is working
No water or ice cube
production
Refrigerator has odor
Moisture forms on
outside of refrigerator
Moisture collects inside
(in humid weather, air
carries moisture into
refrigerator when doors
are opened)
Possible Causes
Icemaker turned off or
water supply turned off.
Ice cubes are frozen to
icemaker feeler arm.
Irregular ice clumps in
storage container.
Water filter clogged.
Water dispenser has not been
used for a long time.
Poor-tasting incoming water.
Dirty water filter.
Normal when refrigerator
is first installed.
Water dispenser has not been
used for a period of time.
Water supply line turned
off or not connected.
Air may be trapped in the
water system.
Water filter clogged.
Water in reservoir is
frozen.
Ice cubes stuck in icemaker.
(Green power light on
icemaker blinking.)
Supply line or shutoff
valve is clogged.
Water filter clogged.
Foods transmitting
odor to refrigerator.
Interior needs cleaning.
Not unusual during
periods of high humidity.
Too frequent or too
long door openings.
What To Do
• Turn on icemaker or water supply.
• Remove cubes.
• Break up with fingertip pressure and discard
remaining clumps.
•Freezer may be too warm. Adjust the freezer control
to a colder setting, one position at a time, until
clumps do not form.
•Replace filter cartridge or remove filter and install plug.
• Dispense 2 quarts (2 L) of water so that all water in
system is replenished.
•Install a water filter.
•Replace filter.
• Wait 24 hours for the refrigerator to completely
cool down.
•Dispense more water. It is normal for the first half-glass
of water to be warm because this water has been resting
in the tube between the chilling reservoir and the
dispenser.
• See Installing the water line.
•Press the dispenser pad for at least two minutes.
•Replace filter cartridge or remove filter and install plug.
•Call for service.
•Turn off the icemaker, remove cubes, and turn the
icemaker back on.
•Call a plumber.
•Replace filter cartridge or remove filter and install plug.
• Foods with strong odors should be tightly wrapped.
• Keep an open box of baking soda in the refrigerator;
replace every three months.
•See Care and cleaning.
•Wipe surface dry.
www.GEAppliances.com
33

Publicité

Chapitres

Table des Matières
loading

Table des Matières