Product Description; Assembly And Use; Technical Data - Abicor Binzel xFUME FLEX Mode D'emploi

xFUME FLEX

4 Product description

4.1 Assembly and use

Fig. 2
A Extraction arm
B Handle
C Service door
D On/Off switch
E 4 × castors
H
G
F
The device is part of a welding, cutting and grinding system. Welding fumes, which are hazardous to health,
are generated during welding and grinding, and during laser and plasma cutting. The fumes are filtered and
cleaned by the filters inside the device. Welding fumes are extracted through an extraction hood and hose
system and then forced through filter elements. The standard configuration of the device has a pre-filter and
a primary filter. The pre-filter removes coarse dirt particles from the extracted welding fumes. Fine dirt
particles are removed by the primary filter. The dirt particles adhere to the surface of the filter material, which
causes the intake pressure on the fan to increase. The cleaned air is then returned via an air exhaust louver.
The device can be operated with a flexible extraction arm with a length of 2, 3, or 4 meters.
The device corresponds to the welding fume separation class H13.

4.2 Technical data

Tab. 1
Connection voltage
Drive power
Line frequency
Primary filter surface area
Pre-filter surface area
Air inlet
Air outlet
Max. air volume flow
Sound pressure level LpA
Weight of device incl. extraction arm
Dimensions (L x W x H)
Length of extraction arm
Assembly and use
General information
4 Product description
F Extraction hood
G LED light
H Light switch
I Pre-filter
J Primary filter
A
B
C
I
D
J
E
115 V
1.1 kW
50 Hz/60 Hz
36 m²
0.43 m²
Ø = 170 mm
310 × 142 mm
1200 m³/h
≤ 72 dB (A)
120–129 kg
700 mm × 700 mm × 1095 mm
2000, 3000 or 4000 mm
230 V
50 Hz
EN - 9