Safety; Designated Use; Obligations Of The Operator - Abicor Binzel xFUME FLEX Mode D'emploi

2 Safety

2 Safety
This chapter describes the essential safety requirements and warns of residual hazards that should be kept
in mind to operate the product safely. Non-observance of the safety instructions may result in risks to the life
and health of personnel, and environmental damage or material damage.
► Please observe the attached "Safety Instructions" document.
► Consult the documentation for additional welding components.

2.1 Designated use

The device described in these operating instructions may be used only for the purpose and in the manner
described in these operating instructions. The device is used to extract welding fumes and dust that is
generated during welding. The device can be used to extract fumes and dust when welding or cutting steel
with an alloy content of nickel and chrome under 30%. Any other use is considered improper. Unauthorized
modifications or changes to enhance the performance are not permitted.
► Do not exceed the maximum load data as defined by the documentation supplied. Excessive loads lead
to irreparable damage.
► Do not make any constructive changes to this product.
► Do not use or store the device outdoors where it is wet.
► During welding work outdoors, use suitable protection against the weather conditions.
► Ensure that the volume flow that is led back to the work area during operation does not exceed
50% of the supply air of the installation area. In the event of free room ventilation, the supply
air flow corresponds to one room volume per hour. This equals a ventilation rate of 1/h
(supply air flow [m³/h] = room volume [m³] × ventilation rate [1/h]).

2.2 Obligations of the operator

Risk of injury due to electromagnetic fields
The device can produce electromagnetic fields that could impact the proper function of cardiac
pacemakers and implanted defibrillators.
► Do not use the device if you have a pacemaker or an implanted defibrillator.
► The device may be used only in industrial zones according to DIN EN 61000-6-3.
► Ensure that only qualified personnel are permitted to perform work on the device or system.
Authorized personnel are:
— those who are familiar with the basic regulations on occupational safety and accident prevention;
— those who have been instructed on how to handle the device;
— those who have read and understood these operating instructions;
— those who have been trained accordingly;
— those who are able to recognize possible risks because of their special training, knowledge,
► Keep untrained persons out of the work area.
Country-specific obligations of the operator
The recirculation of filtered air can lead to health risks and is therefore prohibited in certain countries.
For example, when operating the device in France, the cleaned air must be expelled from the building.
► Observe the local occupational health and safety regulations.
EN - 6
WARNING
and experience.
xFUME FLEX