Publicité
5.
If the supply cord to the battery charger is damaged, contact an
Authorized Service Dealer to replace it.
6.
Charge the battery pack with only the battery charger specified by
Toro. A charger suitable for 1 type of battery pack may create a risk
of fire when used with another battery pack.
7.
Charge the battery pack in a well-ventilated area only.
8.
Follow all charging instructions and do not charge the battery pack
outside of the temperature range specified in the instructions.
Otherwise, you may damage the battery pack and increase the risk
of fire.
9.
Do not operate the tool without all guards and other safety protective
devices in place and functioning properly on the tool.
10.
Dress properly—Wear appropriate clothing, including eye protection;
long pants; substantial, slip-resistant footwear; rubber gloves; and
hearing protection. Tie back long hair and do not wear loose clothing
or loose jewelry that can get caught in moving parts. Wear a dust
mask in dusty operating conditions.
III. Operation
1.
Avoid dangerous environments—Do not use the tool in rain or in
damp or wet locations.
2.
Use the proper tool for your application—Using the tool for purposes
other an its intended use could prove dangerous to you and
bystanders.
3.
Prevent unintentional starting—Ensure that the switch is in the O
position before connecting to the battery pack and handling the tool.
Do not carry the tool with your finger on the switch or energize the
tool with the switch in the O
4.
Operate the tool only in daylight or good artificial light.
5.
If the tool strikes an object or starts to vibrate, immediately shut off
the tool, wait for all moving parts to stop, and disconnect the battery
before examining the tool for damage. Make all necessary repairs
before resuming operation
6.
Remove the battery pack from the tool before adjusting it or changing
accessories.
7.
Keep your hands and feet away from the cutting area and all moving
parts.
8.
Shut off the tool, remove the battery pack from the tool, and wait
for all movement to stop before adjusting, servicing, cleaning, or
storing the tool.
position.
N
6
FF
Publicité
