Publicité
Maintenance
After each use of the edger, complete the following:
1.
Remove the battery from the edger.
2.
Wipe the edger clean with a damp cloth. Do not hose the edger
down or submerge it in water.
3.
Wipe or scrape clean the cutting head area any time there is an
accumulation of debris.
4.
Check and tighten all fasteners. If any part is damaged or lost, repair
or replace it.
5.
Brush debris away from air intake vents and exhaust on motor
housing to prevent the motor from overheating
Replacing the Blade
If the blade becomes worn, bent, or damaged, replace it; contact your
Authorized Service Dealer.
1.
Ensure that the battery is removed from the machine.
2.
Secure the blade so that it cannot spin by inserting a screwdriver (not
included) to the slot in the edger head as shown in
Note:
You may need to turn the blade to find the slot
3.
Remove the blade nut by turning it clockwise using the edger
adjustment tool provided
1. Rotate clockwise to loosen the blade
nut
(Figure
13).
Figure 13
2. Rotate counterclockwise to tighten the
blade nut
24
(Figure
5).
Figure
14.
g334038
Publicité
