Additional light
Choose the operating mode of the lighting device connected to the output.
[FUNCTIONS]
B1-B2 output
Confi gure the contact.
[FUNCTIONS]
Slowdown speed
Set the slowdown speed.
[FUNCTIONS]
Number of motors
Set the number of motors that control the gate.
[FUNCTIONS]
Motor type
Set the type of gearmotor installed.
[FUNCTIONS]
Sleep Mode
This reduces the consumption of the photocells when they are in standby.
[FUNCTIONS]
CRP address
Set the peripheral number. This function is needed where there are multiple operators in the same system.
[FUNCTIONS]
[Light E]
[Output B1-B2]
[Slow. speed]
[No. motors]
[Motor type]
[Sleep Mode]
[CRP address]
[Courtesy]
The light stays on for 5 minutes.
[Cycle] (Default)
The lamp stays on during the manoeuvre.
The light remains off if an automatic closing time
is not set.
[Monostable] (Button)
[Bistable] (Switch) (Default)
[M1+M2] (Default)
[M2]
[FROG] (Default)
[AXO]
[FAST]
[FERNI]
[FROG-PLUS]
[Deactivated] (Default)
[Activated]
from [1] to [32]