CAME ZM3E Manuel D'installation page 35

• Demarcate the entire site properly to prevent unauthorised personnel from entering,
especially minors. • Use suitable protection to prevent any mechanical hazards due
to persons loitering within the operating range of the operator. • The electrical cables
must pass through special pipes, ducts and cable glands in order to guarantee
adequate protection against mechanical damage. • The electrical cables must not
touch any parts that may overheat during use (such as the motor and transformer). •
Before installation, check that the guided part is in good mechanical condition, and
that it opens and closes correctly. • The product cannot be used to automate any
guided part that includes a pedestrian gate, unless it can only be enabled when the
pedestrian gate is secured. • Make sure that nobody can become trapped between
the guided and fi xed parts, when the guided part is set in motion. • All fi xed controls
must be clearly visible after installation, in a position that allows the guided part
to be directly visible, but far away from moving parts. In the case of a hold-to-run
control, this must be installed at a minimum height of 1.5 m from the ground and
must not be accessible to the public. • If not already present, apply a permanent
tag that describes how to use the manual release mechanism close to it. • Make
sure that the operator has been properly adjusted and that the safety and protection
devices and the manual release are working properly. • Before handing over to the
fi nal user, check that the system complies with the harmonised standards and the
essential requirements of the Machinery Directive (2006/42/EC). • Any residual risks
must be indicated clearly with proper signage affi xed in visible areas, and explained
to end users. • Put the machine's ID plate in a visible place when the installation is
complete. • If the power-supply cable is damaged, it must be immediately replaced
by the manufacturer or by an authorised technical assistance centre, or in any case,
by qualifi ed staff , to prevent any risk. • Keep this manual inside the technical folder
along with the manuals of all the other devices used for your automation system.