GE WSLP1500 Manuel D'utilisation Et D'installation page 24

Before you call for service...
Troubleshooting Tips
NOISE
Washer is noisy
OTHER
Labels on the exterior
of the washer will not
peel off cleanly
24
POSSIBLE CAUSES
Washer is uneven
Washer load is unbalanced
Washer is sitting too close to wall
POSSIBLE CAUSES
Occasionally the adhesive used on
the labels does not release cleanly
WHAT TO DO
• Level the washer. See Leveling the Washer.
• Press the Start/Pause button to stop the washer, open
the lid and redistribute the load evenly. Close the lid
and restart.
• Pull washer away from the wall; about 4" is needed
WHAT TO DO
• Use a hair dryer set at the lowest heat setting, directing
the air at the label for a short amount of time. This will
release the adhesive easily, without damaging the
surface of the washer.