GE WSLP1500 Manuel D'utilisation Et D'installation page 22

Before you call for service...
Troubleshooting Tips
WATER
Too many suds
Water leaks
Water temperature is
incorrect
Water won't drain
OPERATION
Washer pauses in cycle
Washer won't operate
22
POSSIBLE CAUSES
Type of detergent
Very soft water
Too much detergent
Fill hoses or drain hose is
improperly connected
Household drain may be clogged
Constant water pressure to the fill
hoses at the water source
Using too much detergent in
washer
Water supply is turned off or
improperly connected
Water valve screens are stopped
up
House water heater is not set
properly
Drain hose is kinked or improperly
connected
Pump clogged
POSSIBLE CAUSES
The washer normally pauses
between washing steps
Washer is unplugged
Water supply is turned off
Controls are not set properly
Lid is open
Circuit breaker/fuse is tripped/
blown
Washer has not been turned on
WHAT TO DO
• Switch to HE detergent.
• Try less detergent.
• Measure your detergent carefully. Use less soap if you
have soft water, a smaller load or a lightly soiled load.
• Make sure hose connections are tight at faucets and
the washing machine. Make sure the end of the drain
hose is correctly inserted and secured to the drain.
• Check household plumbing. You may need to call a
plumber.
• Tighten hoses at the faucets and turn the water off
after each use.
• Check condition of the fill hoses; they may need
replacement after 5 years.
• Use less detergent. Use less soap if you have soft
water, a smaller load or a lightly soiled load.
• Turn both hot and cold faucets fully on and make sure
hoses are connected to correct faucets.
• Turn off the water source and remove the water
connection hoses from the upper back of the washer.
Remove screens and use a brush or toothpick to clean
the screens in the machine. Reinstall screens, reconnect
the hoses and turn the water back on.
• Make sure house water heater is delivering water at
120°F–140°F (48°C–60°C).
• Straighten drain hose and make sure washer is not
sitting on it.
• Top of drain outlet should be less than 8 ft. above floor.
• Remove and clean pump filter.
WHAT TO DO
• Make sure cord is plugged securely into a working
outlet.
• Turn both hot and cold faucets fully on.
• Make sure all selections have been made.
• Close lid and press Start/Pause.
• Check house circuit breakers/fuses. Replace fuses or
reset breaker. Washer should have separate outlet.
• Press the Power button.