Publicité
>
Change the value using the arrow buttons /▲▼ and then OK.
You can call up this default setting at any time under My EQ.
20.3 Internet settings
>
Select MENU > [System settings] > [Internet settings] and press OK.
In this menu you will find some settings and information about the Internet connection.
>
Select Network wizard to establish a WLAN connection.
The network wizard now searches for all WLAN networks within range and
displays them.
>
Then select your Wi-Fi network using the▲ /▼ and OK buttons.
You can now choose whether you want to use the WPS function or enter
your WLAN password manually.
>
If you want to use the WPS function, first start it on your router according
to its operating instructions and then select [Press button] in the network
wizard.
Please note the display messages. The connection process is usually
completed after a few seconds and the WLAN connection can now be used.
Alternatively, the [PIN] function can also used if this function is supported by
the router.
>
If you want to enter your WLAN password manually or your router does not
support the WPS function, select [Skip WPS].
>
Then enter your WLAN password using the virtual keyboard that appears and
confirm by selecting OK.
While the virtual keyboard shown on the display, you can ▲
/▼ and /◀▶ buttons the remote control. The buttons▲ /▼ move the
marker up and down, the buttons /◀ ▶ move the marker to the right and left.
Then select
connection to this network will now be established. You can recognise
whether a connection is established by the signal bar
the display.
To cancel the entry, select
typing error, you can delete the last letter entered by pressing
and press the OK button. If the password was correct, a
and press the OK button. If you have made a
in the status bar of
.
41
Publicité
