Publicité
8.2 Switching the device on/off
>
To switch on your DIGITRADIO 760 CD IR, press the
on the remote control or on the front panel.
The radio now plays the last selected operating mode.
>
To switch it offpress the
When you switch on the DIGITRADIO 760 CD IR for the first time, you
must first select the operating language using the arrow buttons
/▲▼ . Then press the OK button. Read the data protection
information and press the OK button again. You can then select the
Start the initial setup wizard. For more information, see chapter 9 on page
24.
8.3 Navigating the menu
Menu navigation is mainly carried out using the MENU, /▲▼ , BACK and
OK on the remote control or MENU, BACK, OK and
The device menu is divided into the respective submenu of the currently selected
source, the system settings and the main menu. Press the MENU button to open
the device menu.
Use the buttons /▲▼ (in some functions also with /◀▶ ) on the remote control or
TUNING
on the device to navigate through the settings and options. Press the OK
button to make a selection or activate a function.
An "*" marks the current selection.
>
Press the BACK button to go back one step.
Close the menu: Press the MENU or BACK button several times (depending
on which submenu you in) until the current playback source is displayed
again.
Settings are only saved by pressing the OK button. If the BACK button is
pressed in the meantime, the settings are not accepted and saved (the
MENU button also takes on the function of a "Back" button and the menu
is exited).
Functions and buttons to be pressed are described in these operating instructions
in
feU is shown. Display indications in [square brackets].
Some texts (e.g. menu entries, station information) may be too long to be
shown on the display. After a short time, these will then be displayed as a loud
text.
On/Standby button again.
On/Standby button
TUNING
on the device.
21
Publicité
