Publicité
6. To Lower Lift:
NOTICE
NOTICE
A. Remove all tools or other objects
from lift area.
B. Raise lift off locking latches.
C. Pull LATCH release handle fully and
hold.
D. Pull LOWERING valve handle to
lower, Fig. 3.
Proper maintenance
Do not operate
and inspection
a damaged lift.
is necessary
for safe operation.
Note: Both LATCH release and
LOWERING valve handles are deadman-
CAUTION
WARNING
type design. Each must be held down to lower lift . Do not
override self-closing lift controls.
7.
Remain clear of lift when lowering vehicle. Observe pinch
point warning decals.
8.
Remove adapters from under vehicle and swing arms to full
Remain clear of lift
Always use
drive-thru position before moving vehicle.
when raising or
safety stands when
lowering vehicle.
removing or installing
heavy components.
9.
If lift is not operating properly, Do Not use until adjustment
or repairs are made by qualified lift service personnel.
Typical Wheel Spotting Positions
*Maximum operation pressure is:
3263 psi for Standard
3263 psi for Wide
3263 psi for Sprinter
Typical Lift Points
Do not operate
a damaged lift.
Truck
WARNING
Keep feet
clear of lift
while lowering.
WARNING
Do not override
self-closing
lift controls.
Fig. 1
Truck Frame
Lift
Adapter
A
Section "A - A"
A
Fig. 2
NOTICE
Proper maintenance
and inspection
is necessary
for safe operation.
CAUTION
Always use
safety stands when
removing or installing
heavy components.
Latch
Release
Latch
Release
Most specialty or modified vehicles cannot be
WARNING
raised on a frame engaging lift. Contact vehicle
manufacturer for raising or jacking details.
Positioning the vehicle
Due to varying centers of gravity within different vehicle class-
es, use the dish as a guide only and locate the arms between the
vehicle pickup points. Always position vehicle with its center of
gravity in line with lift columns. Slightly raise vehicle and check
for stability. Do this by pushing up & down on the front and rear
bumpers. The vehicle should sit firmly on all pickup points. If
necessary, relocate arms and/or vehicle to attain a stable condi-
tion. Also refer to the ALI Safety Manual included with the lift.
45
NOTICE
WARNING
Keep feet
Do not operate
a damaged lift.
clear of lift
while lowering.
WARNING
WARNING
Remain clear of lift
Do not override
when raising or
self-closing
lowering vehicle.
lift controls.
Lift Controls
Raise
Switch
Fig. 3
Lowering Valve
Handle
Raise
Switch
Lowering
Valve
Handle
Publicité
