Eskimo QuickFlip 2 Manuel De L'opérateur page 18

EsiStM,41
Operator's Manual
Quickflip T" 2(69167) and Quickflip " 3(69168) Sled-Style Shelters
FAQ'S: (Frequently Asked Questions)
How can I keep mice and other rodents from damaging my ice shelter?
During the off season, you should always remove your ice shelter skin, padded seats and padded backrests from the sled and poles and make
sure it is dry. Fold skin up, store items in a large plastic container with lid and store in a cool, dry place.The use of moth balls or dryer sheets may
be helpful also.
My poles are noisy and don't run as smooth as they did originally. Is there a fix?
Applying WD-40° or a similar type of silicon spray works well for lubricating the poles for easier operation and also deters from corrosion. You
should do this maintenance at least seasonal, especially before storing for long term periods. Wipe off excess lubricant so it does not damage
your ice shelter skin. Using a rod with a cloth attached to the end of it, apply the WD-40 or silicon lubricant to the rag and wipe the inside of the
large poles so they have a lubricated surface for the hinge poles to slide on.
My zipper functions roughly or freezes up from snow/ice. How can I fix this?
You can try a silicon spray to help lubricate it, or purchase an actual Zipper Lube° brand lubricant found in many sporting goods stores, in the
camping section. Either way, use with caution and wipe off excess lubricant so it does not damage your ice shelter skin.
For attaching the edge trim to my skin and sled, do I actually drill holes through the skin?
Yes, this is the best way to make a seal between the skin and sled. It also keeps the edge trim securely in place and will not fall off during trans-
port. If you remove the skin from the poles and sled during the off season, the skin will go back on the same way and
you should be able
to use the same holes for the screws as you did the previous season.
The edge trim is hard to put on the sled lip, is there a secret?
You should apply the edge trim to the sled lip at room temperature which makes it more pliable.The use of a rubber mallet will help too. '
Why are my windows turning cloudy when they get wet?
Sometimes if your windows get extremely wet the moisture can penetrate the windows which gives them a cloudy appearance.This can easily
be remedied by removing the windows and bringing them into a warm environment (indoors) and letting the moisture retreat from the window
which will clear them back up to the original appearance.
I have a tear in my skin, how do I repair it?
You can call or e-mail us to purchase a patch kit which consists of a 12"x 12"piece of skin material and an adhesive to apply the patch to the tear
area. This should be done at room temperature. Allow at least 24 hours for adhesive to set to assure proper adhesion.
My shelter lets some water come through it, how can I remedy that?
You may purchase a seam sealer or silicon spray to help seal the seams to help repel water, such as Camp Dry .° which can be found in many
sporting goods stores, in the camping section. See Important Safety Precautions on page 4. Eskimo ice shelters are not water proof.
I can see small pin holes in my shelter skin, why?
The coating on the inside of shelter skin is done to help darken the interior.The pin holes are normal and may increase from normal exposure to
the elements or from normal wear and tear. This will not affect the performance of the ice shelter in any way and is normal.
I can see cracks on the inside of my shelter skin, why?
This is also normal due to exposure to the elements and normal wear and tear. When you fold your shelter for transport, lines and creases de-
velop in the fabric. This will not affect the performance of the ice shelter in any way
Will my ice shelter leak from the small pin holes in skin?
Many variables can come into play. It depends on the outside air temperature, the air temperature inside the shelter, how much heat you
are using inside shelter, etc. Some leaking could occur due to condensation, but that is normal. This can be controlled better
by using
the numerous air vents, windows and doors that are on your shelter.
Do I have to have a tracking kit to tow my ice shelter?
For high speed towing behind a snowmobile or ATV, we highly recommend you purchase a high speed tracking kit so you do not cause unneces-
sary or premature damage to your ice shelter sled. If you are only going to pull your ice shelter by hand, a high speed tracking kit is not necessary,
but does make it easier to pull.
Can I wash my ice shelter skin?
You can use a mild bleach and water solution to get rid of mold or mildew. If you are just wanting to wash your skin, you can use a mild soap and
water mixture. Do not machine wash your skin.
Check for parts online at www.geteskimo.com or call 800-345-6007 M-F 8-5 CST
18