Becker Centronic SunWindControl SWC745-II Notice De Montage Et D'utilisation page 46

DELAY (only when EXPERT MODE is ON)
The delay time
mins.
The delay time
value being exceeded and the extend command.
This value can be set manually.
The delay time
below the SUN
This value can be set manually.
END POSITION
When the sun protection system is fully extended or retracted, this is
described as an end position.
INTERMEDIATE POSITION
The intermediate position is a freely selectable position of the sun
protection system, between the retracted and extended end posi‐
tions. Once programmed, this position can be travelled to from the
retracted position.
To do so, press the EXTEND button briefly twice in succession.
For venetian blind operation, any tilt which has been set is automati‐
cally carried out following the intermediate position.
FABRIC TENSION/TILT
The fabric tension/tilt position is a freely selectable position of the
sun protection system/venetian blind between the retracted and ex‐
tended end positions. With this function, you can tension the fabric
of your sun protection system.
With the venetian blind, the slats can be tilted.
To do so, press the RETRACT button briefly twice in succession.
WINTER OFF/ON
If the WINTER ON function is activated, no automatic or manual drive
commands will be executed.
WIND MONITORING
The threshold value for WIND is preset to 04.
The threshold value can be set to anywhere between 01 (little wind)
and 11 (very windy).
46
is preset to 3 mins and the delay time
denotes the time between the SUN
denotes the time between the brightness falling
threshold value and the retract command.
to 15
threshold