Central Command - Becker Centronic SunWindControl SWC745-II Notice De Montage Et D'utilisation

Central command

If all the channels of the transmitter are selected, it is possible to op‐
erate all of the assigned receivers/groups simultaneously.
Channel selection button
Note
Channel selection is only possible in Operating
mode.
Up to 5 channels can be selected using the channel selection but‐
ton. The individual channels are indicated by the corresponding
channel indicator lamp lighting up. If all of the channel indicator
lamps light up simultaneously, the central command can be trans‐
mitted.
Note
You can make a note of the programmed channel in
the labelling field underneath the transparent film.
Channel indicator lamps
A radio signal is indicated by the corresponding channel indicator
lamp lighting up.
The transmission strength and the radio range decrease as battery
power declines. If the channel indicator lamp no longer lights up
when a button is pressed, the battery must be replaced.
41