Internal Water Dispenser - GE 26 Manuel D'utilisation Et D'installation

About the controls.
Spill Shelf
Push
Important Facts About Your Dispenser
Do not add ice from trays or bags to the storage drawer.
It may not crush or dispense well.
Avoid overfilling glass with ice and use of narrow
glasses. Backed-up ice can jam the chute or cause
the door in the chute to freeze shut. If ice is blocking
the chute, poke it through with a wooden spoon.
Beverages and foods should not be quick-chilled in
the ice storage drawer. Cans, bottles or food packages
in the storage drawer may cause the icemaker or auger
to jam.
To Use the Dispenser
Select Cubed Ice , Crushed Ice
Water by pressing the Ice & Water pad.
Press the glass gently against the top
of the dispenser cradle.
The spill shelf is not self-draining.
To reduce water spotting, the shelf should
be cleaned regularly.
To Lock and Unlock the Dispenser
To lock, press and hold the Ice Off/Lock pad
for 3 seconds. Repeat this step to unlock the
dispenser.

Internal Water Dispenser

To use the internal water dispenser, place a
glass underneath the water outlet and push
gently against the dispenser with your glass.
About Door Alarm
(on some models)
The door alarm will sound if any
door is open for more than 3 minutes.
The beeping stops when you close the door.
About Energy Saver
This product is equipped with an Energy
Saver feature. The refrigerator is shipped
with the Energy Saver feature on.
Over time, moisture can form on the front
surface of the refrigerator cabinet and cause
(on some models)
If no water is dispensed when the refrigerator
or
is first installed, there may be air in the water
line system. Press the dispenser arm for at
least two minutes to remove trapped air from
the water line and to fill the water system.
To flush out impurities in the water line, throw
away the first six full glasses of water.
CAUTION:
or any other objects into the ice crusher
discharge opening.
(on some models)
(on some models)
To keep dispensed ice from missing the glass,
put the glass close to, but not touching, the dispenser
opening.
Some crushed ice may be dispensed even though you
selected Cubed Ice. This happens occasionally when
a few cubes accidentally get directed to the crusher.
After crushed ice is dispensed, some water may drip from
the chute.
Sometimes a small mound of snow will form on the door in
the ice chute. This condition is normal and usually occurs
when you have dispensed crushed ice repeatedly.
The snow will eventually evaporate.
About Dispenser Light
Press and hold the Alarm/Light pad for
3 seconds to turn on the dispenser light.
To turn off, press and hold the pad again
for 3 seconds.
rust. If moisture does appear on the front
surface of the refrigerator cabinet, turn off
the Energy Saver feature by pressing
and releasing the Energy Saver pad
on the control panel.
ge.com
Never put fingers
(on some models)
5