Internal Water Dispenser - GE PYE18HMLKES Guide D'utilisation Et D'entretien Rapide

About the temperature controls.
Not all features are on all models. Your controls may be similar to the following:
Figure A
Note: Do not block air outlet by placing food items directly
against it. Erratic temperatures may result.
Figure B
Models with Figure A, The temperature controls knobs are preset in the
Factory at Colder / Colder position for both refrigerator and Freezer
compartments. Allow 24 hours for temperature to stabilize to the preset
recommended settings.
Knob position temperature guide
Refrigerator
Coldest 34°F (1.1°C)
Colder 37°F (2.8°C)
Cold 44°F (6.7°C)
Models with Figure B and C, The temperature controls are preset in the
factory at 37°F for the refrigerator compartment and 0°F for the freezer
compartment. Allow 24 hours for the temperature to stabilize to the preset
recommended settings.
About the water dispenser.
Spill Shelf
FEATURES
(Not all features are on all models)
Freezer
Coldest -6°F (-21.1°C)
Colder 0°F (-17.8°C)
Cold 6°F (-14.4°C)
(on some models)
Dispenser
(on some models)
Press the glass gently against the dispenser cradle.
The spill shelf is not self-draining. To reduce water spotting, the shelf should be cleaned regularly.
If no water is dispensed when the refrigerator is first installed, there may be air in the water line system. Press the
dispenser arm for at least two minutes to remove trapped air from the water line and to fill the water system. To
flush out impurities in the water line, throw away the first six glassfuls of water.

Internal Water Dispenser

The water dispenser is located on the left wall inside the refrigerator compartment.
To dispense water:
Hold the glass against the recess.
Push the water dispenser button.
Hold the glass underneath the dispenser for 2–3 seconds after releasing the dispenser button. Water may
continue to dispense after the button is released.
NOTE: To avoid water deposits, the dispenser should be cleaned periodically by wiping with a clean cloth or sponge.
Figure C
Door Alarm (on some models)
To set the alarm, press this pad.The indicator light will come on (models
with Figure C controls only). This alarm will sound if either door is open
for more than 2 minutes. The beeping stops when you close the door.
TurboCool
TM
Models with figure B: To set the TurboCool™ press Turbo Cool pad for 3
seconds. Display will show tc.
Models with figure C: To set the TurboCool™ press Alarm pad for 3 seconds.
Display will show tc.
TurboCool™ rapidly cools the refrigerator compartment in order to more
quickly cool foods. Use TurboCool™ when adding a large amount of the
foods after they have been sitting out at room temperature or when
putting away warm leftovers. It can also be used if the refrigerator has
been without power for an extended period.
NOTES: The refrigerator temperature cannot be changed during
TurboCool™. The freezer temperature is not affected during TurboCool™.
When opening the refrigerator door during TurboCool ™, the fans will
continue to run if they have cycled on.
NOTE Fig. B & C: To put the refrigerator control in the OFF position,
simultaneosly touch the words Freezer and Fridge for 3 seconds.
Power to the refrigerator cannot be disconnected by any setting
on the control panel.
(on some models)
3