Oscartielle Vega G.I. 109 Mode D'emploi page 30

18 - Multiplexing cabinets
To multiplex two or more Vega cabinets, follow the instructions below:
1. Move the cabinets together on their feet to obtain perfect alignment (Ref. 1).
2. Fit the five prongs D4x40 UNI7589 in their housings (no. 2 pcs. in the front of the basin and no. 3 in the lighting) (Ref.
1 - 5 at page 6).
3. Join the uprights with one threaded bar M6x45 and two bosses M6 (Ref. 6 – 8 at page 6)
4. Fasten the bases together with the four threaded bars M8x125, the four nuts diam. 8 and eight washers M8 supplied
(Ref. 9 – 10 at page 10).
5. Join the working shelves with two M8x60 screws and two M8 nut (Ref. 11 – 12 at page 7).
6. Fasten the basin fronts together with the M6x45 screw and nut (Ref. 2).
7. Align the superstructures by joining the uprights with an M6x45 screw and nut (Ref. 3).
Complete assembly of the cabinet as described in Par. 5.
19 - Diagram for cables and pipe installation
Diagram for cables and pipe installation can be seen at page 8 FIG. 17 and at page 9 FIG. 18 for the corners.
20 - Wiring diagrams
The diagrams can be seen from page 10 to page 14.
Legend:
C1 = solenoid compressor no. 1 display
CE = electronic control
CO = power factor correction condenser
D = defrosting heating element (Optional))
IG = main circuit breaker
IL = light switch
K1 = relay compressor
K2 = relay defrost
K3 = end defrost klixon (optional)
LV = display light
M = motor
M1 = display compressor
M2 = storage compressor
PC = control panel
QE = power panel
RE = reactor
RG = fan speed regulator (optional)
ST = temperature probe
TR = transformer 230V / 12V
Va = anti-mist fan
Vm = motor fan
Vv = display fan
21 - Conformity Declaration
A copy of the declaration of product conformity can be requested by filling in the form available a the internet address:
http://www.oscartielle.it/conformity
28