Philips HU5710 Manuel D'utilisation page 15

English
14
Water level
Auto QuickDry mode
Manual QuickDry mode
Refilling water
40
When there is not enough water in the water tank, the
humidifier will start Auto QuickDry mode by default. During this period, the
humidification amount may decrease until you refill water into the water tank.
The humidifier will turn on auto wick dry function by default when the
indicator on to accelerate filter drying after usage，promoting hygienic
maintenance， and prolonging the filter's lifespan. The process of drying can
take around 4 hours depending on the conditions of the room. You can turn off
this function in the Air+ app.
You can use this setting to accelerate drying the filter before you store it. You
need to empty the water tank first before start this function. You can only use
this function in the Air+ app.
Note:
When filling water, do not exceed the maximum water level, or water might leak
from the air inlets.
Do not shake the water tank when moving it, or water might leak from the air
inlets.
Do not fill water through the air outlets on top of the humidifier.
There are two methods for refilling water: directly refilling water or refilling
water through the side water-filling inlet.
-
Directly refilling water using a water tap
indicator is on, the