Designated Use; Classification Of The Warnings - Abicor Binzel ABIPLAS CUT Mode D'emploi

®
ABIPLAS CUT
1 Identification
Manual and machine torches from the ABIPLAS
plasma cutting and gouging with compressed air as the plasma and cooling gas in industrial
and commercial applications. They consist of the torch body with equipment parts and wear
parts, handle and cable assembly with a direct or central connector. They conform to
EN 60974-7 and are not considered devices that independently fulfil functions. For operation,
a cutting power source is required.
The ABIPLAS
ABICOR BINZEL spare parts.
1.1 Marking
This product fulfills the requirements that apply to the market to which it has been introduced. A
corresponding marking has been affixed to the product, if required.
2 Safety
The attached safety instructions must be observed.

2.1 Designated use

• The device described in these instructions may be used only for the purpose and in the
manner described in these instructions. In doing so, observe the operating, maintenance
and servicing conditions.
• Any other use is considered improper.
• Unauthorised modifications or changes to enhance the performance are not permitted.

2.2 Classification of the warnings

The warnings used in the operating instructions are divided into four different levels and shown
prior to potentially dangerous work steps. Arranged in descending order of importance, they
have the following meanings:
DANGER
Describes an imminent threatening danger. If not avoided, this will result in fatal or extremely
critical injuries.
WARNING
Describes a potentially dangerous situation. If not avoided, this may result in serious injuries.
CAUTION
Describes a potentially harmful situation. If not avoided, this may result in slight or minor
injuries.
BAL.0099 • 2021-08-20
®
CUT plasma cutting torches must only be operated using original
®
CUT series are intended exclusively for
1 Identification
EN - 3