Drive Shaft; Bevel Gear - Husqvarna 545FR Manuel D'utilisation

2. Open the 2 snap locks that hold the filter frame.
3. Remove the filter frame and the air filter.
4. Examine and clean the air filter housing with a brush.
5. Examine the air filter. Replace the air filter if it is dirty
or damaged.
CAUTION: Do not bend of fold the air filter
as this can cause damage to the air filter.
Replace a damaged air filter.
To clean a nylon air filter (545F, 545FX,
545FXT)
1. Remove the air filter cover.
2. Release the snap locks that hold the air filter.
3. Remove the air filter.
4. Examine and clean the air filter housing with a brush.
5. Examine the air filter. Clean the air filter with warm
soap water.
CAUTION: Replace an air filter that is
damaged.

Bevel gear

The bevel gear is filled to ¾ with grease at the factory.
Before use, make sure that the grease level has not
changed. Use Husqvarna special grease if it is
necessary to fill up. Do not change the grease in the
1018 - 003 - 20.11.2019
bevel gear. Let servicing personnel do the repair of the
bevel gear.

Drive shaft

Lubricate the drive shaft at an interval of 3 months. Let a
service agent help you if you are not sure about the
procedure.
To attach and remove the locknut
WARNING: Stop the engine, use protective
gloves and be careful around the sharp
edges of the cutting attachment.
Use the locknut to attach some types of cutting
attachments. The locknut has a left thread.
25