Angle Gear; Lubricating The Flexible Drive Shaft; Adjusting The Edger's Cutting Depth - Husqvarna 323E Série Manuel D'utilisation

Oiling the air filter
Always use HUSQVARNA filter oil, art. no. 531 00 92-48.
The filter oil contains a solvent to make it spread evenly
through the filter. You should therefore avoid skin contact.
Put the filter in a plastic bag and pour the filter oil over it.
Knead the plastic bag to distribute the oil. Squeeze the
excess oil out of the filter inside the plastic bag and pour
off the excess before fitting the filter to the machine. Never
use common engine oil. This would drain through the filter
quite quickly and collect in the bottom.

Angle gear

The angle gear is filled with a sufficient quantity of grease
at the factory. However, before using the machine you
should check that the angle gear is filled to 3/4 with
grease. Use HUSQVARNA special grease.
The grease in the bevel gear does not normally need to
be changed except if repairs are carried out.
Lubricating the flexible drive
shaft
Inside the hollow drive shaft of the edger is a flexible drive
shaft. This flexible drive shaft should be regularly
lubricated every 25 hours in operation. Loosen the two
screws on the angle gear and remove it. The flexible drive
shaft is easily removed from the hollow shaft by taking a
firm grip on the shaft end. Lubricate the entire length of
the flexible drive shaft and reinsert it in the hollow drive
shaft. Turn the shaft while inserting it so that it correctly
46 – English
MAINTENANCE
engages in the clutch. Refit the angle gear on the hollow
drive shaft and tighten the two screws.
Adjusting the edger's cutting
depth
The cutting depth must be adjusted before starting work.
• Loosen the locking knob (A) and rotate the guard by
moving the locking knob forwards or backwards. If the
locking knob is moved forwards (away from the
machine) the cutting depth is increased. If the locking
knob is moved backwards (towards the machine) the
cutting depth is reduced.
A
• Set the desired cutting depth.
• Lock the locking knob.
CAUTION! Use only HUSQVARNA replacement parts.
Use of other brands of replacement parts can cause
damage to your unit or injury to the operator or others.
Your warranty does not cover damage or liability caused
by the use of accessories and/or attachments not
specifically recommended by HUSQVARNA.
11535649-32 Rev. 5 2014-12-02