Husqvarna 545FR Manuel D'utilisation page 27

• Adjust the blade set to 1 mm with the recommended
setting tool. Refer to the instructions that come with
the blade.
WARNING: Always discard a blade that is
damaged. Do not try to make a bent or
twisted blade straight and use it again.
To examine the spark plug
CAUTION: Always use the recommended
spark plug type. Incorrect spark plug type
can cause damage to the product.
• Examine the spark plug if the engine is low on
power, is not easy to start or does not operate
correctly at idle speed.
• To decrease the risk of unwanted material on the
spark plug electrodes, obey these instructions:
a) Make sure that the idle speed is correctly
adjusted.
b) Make sure that the fuel mixture is correct.
c) Make sure that the air filter is clean.
• If the spark plug is dirty, clean it and make sure that
the electrode gap is correct, refer to
on page 29 .
• Replace the spark plug if it is necessary.
To adjust the product for cold
environments
If the temperature is 5° or colder, adjustments are
necessary to prevent operation problems.
1018 - 003 - 20.11.2019
•
•
•
•
•
Technical data
To lubricate the wire
545FXT
Note: The wire is lubricated at the factory. Lubricate the
wire monthly.
1. Remove the protective cover.
2. Remove the cylinder cover to get access to the
3. Remove the plug on the grease nipple.
Attach the air duct as shown in the illustration. Make
sure that the arrow points in the direction of the
winter mode symbol.
Replace the air filter cover with the winter mode air
filter cover.
If you operate the product in snow, attach a cover on
top of the starter.
For 545FXT, make sure that the wire is lubricated
when you operate the product in cold environments.
At temperatures of more than 5°, change back to the
regular air filter cover. Remove the cover on top of
the starter and adjust the air duct back to the initial
position. Make sure that the arrow points in the
direction of the summer mode symbol.
CAUTION: Do not operate the product at
temperatures of more than than 5° if it is
adjusted for winter mode. The engine
becomes too hot and can be damaged.
rubber bellows on the wire.
27