To Stop The Engine; Heated Handles - Husqvarna 545FR Manuel D'utilisation

4. Hold the body of the product on the ground with your
left hand.
CAUTION: Do not step on the product.
5. Pull the starter rope handle slowly until you feel
some resistance. When you feel resistance, pull the
starter rope handle quickly and with force.
Note: Do not twist the starter rope around your hand.
6. Continue pull the starter rope handle until the engine
starts.
CAUTION: Do not pull the starter rope to
full extension and do not let go of the
starter rope handle. Release the starter
rope slowly. If you do not obey these
instructions it can cause damage to the
engine.
7. Set the choke control to the run position and apply
full throttle.
To start a warm engine (545F, 545FX,
545FXT)
1. Set the stop switch (A) to the start position.
2. Pull the choke control (B) up.
3. Set the throttle trigger (C) to the start position.
4. Push the air purge bulb (D) 10 times. It is not
necessary to fill the air purge bulb fully.
C
B
D
Note: Do not use the decompression valve (E).
5. Pull the starter rope handle quickly and with force.
Pull the starter rope handle until the engine fires.
18
A
E
To start a warm engine (545FR,
545RX, 545RXT)
1. Set the stop switch (A) to the start position.
2. Push the throttle lockout (B) and the throttle trigger
(C).
3. Push the start throttle button (D) while you engage
the throttle trigger (C).
4. Release the throttle lockout and the throttle trigger.
5. Push the air purge bulb (E) 10 times. It is not
necessary to fill the air purge bulb fully.
A
C
E
Note: Do not use the decompression valve (F).
6. Pull the starter rope handle quickly and with force.
Pull the starter rope handle until the engine fires.

To stop the engine

• Move the stop switch to the stop position.

Heated handles

545FXT has heating elements in the handles. There is
an ON/OFF switch on the throttle handle. The heating
elements automatically keep a temperature of 70° when
the heat is on.
D
F
B
1018 - 003 - 20.11.2019