To Stop The Product - Husqvarna 120iTK4-P Mode D'emploi

Masquer les pouces Voir aussi pour 120iTK4-P:

Manuel d'utilisation (792 pages)

Table des Matières

Les langues disponibles

•

Whenever possible, position yourself so that you can

make the cut at right angles to the branch.

•

Cut large branches in sections so that you have

better control over where they fall. You should also

pay attention to the fact that falling branches can

bounce in the direction of the user after hitting

ground.

•

Never cut through the swelling at the root of the

branch as this will slow down healing and increase

the risk of fungal attack.

•

Use the stop at the base of the cutting head to

provide support during cutting. This will help prevent

the cutting attachment from bouncing on the branch.

•

Make an initial cut on the underside of the branch

before cutting through the branch. This will prevent

tearing of the bark, which could lead to slow healing

and cause permanent damage to the tree. The cut

should not be deeper than ⅓ of the branch thickness

to prevent jamming. Keep the chain running while

you withdraw the cutting attachment from the branch

to prevent it jamming.

•

Make sure you have a firm footing and that you can

work without being hampered by branches, stones

and trees.

WARNING:

trigger without having the cutting attachment

in full view.

To start the Boost function

The product has a Boost function. The Boost function

gives stronger power.

1. Push the Boost button. The LED comes on to show

that the function is on.

2. Push the Boost button again to stop the Boost

function.