Maintenance; Maintenance Schedule - Husqvarna 120iTK4-P Mode D'emploi

3. Remove the battery from the product. Push the 2
release buttons and pull out the battery.
Introduction
WARNING:
safety chapter before you do maintenance
work on the product.
WARNING:
you do maintenance on the product.

Maintenance

Clean the external parts of the product with a
dry cloth. Do not use water.
Make sure that the start and stop button
works correctly and are not damaged.
Make sure that the power trigger and the
power trigger lockout function correctly from
a safety point of view.
Make sure that all controls work and are not
damaged.
Keep the handles dry and clean. Makes sure
that that there is no oil and grease on the
handles.
Make sure that the saw chain cover is not
damaged. Replace the saw chain cover if it is
damaged.
Make sure that the screws and nuts are tight.
Clean the oil tank cap
Make sure that the battery release buttons
on the battery works and locks the battery in
the product.
Examine that the battery charger is not dam-
aged and function correctly.
Make sure that the battery is not damaged.
1636 - 003 - 06.04.2021
Maintenance
Read and understand the
Remove the battery before

Maintenance schedule

WARNING:
you do maintenance.
The following is a list of the maintenance steps that you
must do on the product. Refer to the tasks in the
maintenance chapter for more information.
Daily Weekly
X
X
X
X
X
X
X
X
X
X
X
Remove the battery before
Monthly
15