Status Display; Display Of Charge Level/Support Level - Trek FAZUA Manuel Du Propriétaire

26.1 Status display

The status display indicates a status change or an existing fault. If no fault
is detected, the status display LED functions as one of the five LEDs to
display the charge level or the support level set.
The status display LEDs light up in different colours depending on which
status is displayed.
The status display:
• Flashing green = "Ready for operation"
Following successful installation of the drivepack into the e-bike,
the status display flashes green briefly, indicating that you can now
switch on the drive system using Remote fX/Remote bX.
• Flashing yellow = "Soft Fault"
If a "Soft Fault" occurs, the status display flashes yellow.
In this way, the drive system indicates that there is a temporary or
non-critical fault that in most cases will result in reduced perfor-
mance.
If a "Soft Fault" occurs, you will be able to continue riding your
e-bike, but Fazua strongly recommends not doing so to avoid
further faults or damage to the drive system or to the e-bike.
• Flashing red = "Hard Fault"
When a "Hard Fault" occurs, the status display flashes red. If a
"Hard Fault" occurs on your e-bike, the e-bike can no longer be
used and requires maintenance.

26.2 Display of charge level/support level

The charge level/support level display shows two parameters.
• The display for the charge level of the battery:
The charge level of the battery can be read off via the number
of lit LEDs. Each of the 5 LEDs here represents 20 % of the total
charging capacity. When the battery is fully charged, all 5 LEDs
light up.
If the battery is flat, the upper LED of the status indicator lights up
white or no LED lights up.
EN-60
- 70 -
evation |