Use; Inserting And Removing Components - Trek FAZUA Manuel Du Propriétaire

4

USE

This chapter describes chronologically how to proceed when using the
drive system.
► It is essential that you also read the detailed descriptions in the section
relating to the component in question:
• before you use your e-bike equipped with the evation drive system
for the first time,
• if you are unsure how to use it,
• if you have problems performing the steps as described here.

4.1 Inserting and removing components

4.1.1 Inserting the battery into the drivepack
More detailed information can be found
→
battery" and in chapter 31.2 "Inserting the battery into the drivepack".
On delivery, the battery may only be pre-charged.
► Fully charge the battery before inserting it into the drive-
pack for the first time.
1. Check the battery for visible damage.
2. Press the power button on the battery once to turn the battery on.
3. Attach the battery to the battery compartment of the drivepack with
the connector contact first.
4. Carefully insert the battery fully into the battery holder.
The battery will lock automatically if you insert it correctly. If the battery
does not lock, repeat the procedure. Do not use the drive system if the
battery cannot be locked in position.
| evation
in chapter 31.1 "Checking and switching on
A
- 31 -
D
EN-21