Trek FAZUA Manuel Du Propriétaire page 82

The battery is designed so that it can only be inserted into the battery
receptacle when correctly aligned. So, if you have problems inserting
the battery into the battery holder, it may be because you have not
aligned the battery correctly.
Therefore, in this case, first check the correct alignment of the battery
and try inserting it again.
If the battery cannot be inserted into the battery receptacle despite
correct alignment, this may indicate that one of the components is
damaged.
Do not use the drive system if the battery cannot be inserted into the
battery holder, but contact an authorised specialist.
3. Carefully insert the battery as far as possible into the battery holder of
the drivepack until you hear a click.
When you have inserted the battery correctly and completely into the
battery holder, the push button on the battery slides into the corre-
sponding opening on the drivepack and locks the battery in place.
1
If the battery does not lock, pull it out again if necessary, make sure that
there is no dirt inside the drivepack to obstruct insertion, and then try
inserting the battery again. Do not use the drive system if the battery
cannot be locked. In this case, contact an authorised specialist to have
the fault rectified.
EN-70
evation |
- 80 -