Hach Flo-Station Manuel D'utilisation page 13

Figure 7 Sensor connections
1 Strain relief fitting
Pin Flo-Dar sensor wire
(S1)
1 White
2 Black
3 Clear
4 Red
5 Green
6 Black
Connect the analog outputs (optional)
The instrument contains four isolated analog outputs (Channel 1–4). Refer to
analog outputs for analog signaling or to control external devices. Use the Flo-Ware software to
configure each analog output.
1. Remove the main power to the instrument.
2. Remove the bottom cover. Refer to
3. Put the cable through the strain relief fitting near the CP1 terminal block.
4. Remove approximately 6 mm (¼ in.) of insulation from each wire.
5. Install each wire in the terminal block.
Note: Each terminal is labeled (+ or -) for polarity. This is the voltage polarity when a load resistance is put
across the terminals.
6. Tighten each wire connection so that the wires are held securely.
2 APR reference tube
Table 3 Sensor connections
Flo-Tote 3 sensor wire
(S1)
White
Black
Orange
Red
Green
Black
Figure 1 on page 6.
3 Sensor cable
Flo-Dar SVS sensor wire
(S2)
White
Black
Orange
Red
Green
Black
Figure 8. Use the
English 13