Safety Warnings; Environmental Information - Astralpool PAR 56 Manuel D'installation Et D'entretien

7. TROUBLESHOOTING
Problems
The display that indicates the DMX
address does not turn on
The green LED in
modulator does not light up
The projectors change colour or go
out for a few moments
If you are unable to solve the problem with these instructions, contact the technical department of AstralPool.

8. SAFETY WARNINGS:

• Avoid making contact with the electric voltage.
• Comply with the current standards regarding accident prevention.
• In this regard, the IEC 364-7-702 standards must be observed: WIRING IN BUILDINGS SPECIAL WIRING
SWIMMING POOLS
• All maintenance operations should be performed with the lamp disconnected from the Mains.
• Do not handle with wet feet.
• The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric
components which have been inserted or handled at locations other than its own premises.

9. ENVIRONMENTAL INFORMATION

Processing of electrical and electronic equipment after their period of use (Only applicable in the E.U.)
Our goods are designed and manufactured using top quality materials and components, which are
environment-friendly and which can be reused and recycled. This symbol, marked on the equipment
or packaging, means that this equipment can not be processed as normal domestic waste. You
should hand it in to the technician who installs the new equipment or at special collection points for
electric and electronic equipment. Recycling this equipment does not cost you anything and by
separating it from other waste, you are helping to prevent negative consequences for the environment
and for people's health by avoiding incorrect handling. Help us to preserve the Environment. Thank
you.
For detailed information on how to correctly dismantle this equipment for recycling, please contact
us through quality@sacopa.com
Current
equipment
the DMX
Defective DMX signal
Faulty
projectors or in the DMX modulator
Usual causes
is not reaching the
power supply in the
6
Solutions
Check the mains socket (230V~AC)
and the 12 V~ac power line
Check the installation of the DMX
line. Only the line termination of
the last DMX equipment of the
DMX communications bus should
be activated
Check the 12V~AC power supply
line of the projectors and the DMX
modulator