Safety Warnings - Astralpool LUMIPLUS PAR56 1.11 Manuel D'installation Et D'entretien

- Switching spotlights off
- Switching the remote control off
The remote control automatically switches off in less than 60 seconds.
The LED display lights on the remote control only light up for a few seconds.
7.2 Control motion mode (see page 28)
Changing the colour (Fig. A)
- Hold the remote control firmly without touching any of the buttons.
- Flick your wrist downwards.
- The change in colour will be displayed on the Central Display.
(Fig. B)
- Hold the remote control firmly without touching any of the buttons.
- Flick you wrist form side to side.
8. CONTROL MOTION MAINTENANCE:
If the Central Display lights up in red without switching off, this means the batteries are low. The battery case is on the
9. WIRING:
Diagram of the wiring (see page 28)
In order to wire the system properly, a lamp, transformer and the Control Motion unit will be needed.
10. TROUBLESHOOTING:
Problems
The lamp is not working
The lamp projects a different colour
to that shown on the Control Motion
Central Display
Two lamps project different colours
Using the control motion mode, the
lamp does not work
Control Motion is not responding

11. SAFETY WARNINGS:

MING POOLS.
Usual causes
The lamp does not have a power supply
The Control Motion batteries are low
5
Solutions
Connect the lamp to the power
transformer.
1. Get close to the lamp before
sending a command
2. Do not cover the antenna with
your hand
3. Press the REFRESH button
Change the batteries
-