Table des Matières
Publicité
Certifications
SG-x-H
DECLARATION OF CONFORMITY
According to Regulation (EC/EU) No.1935/2004 Article 3, it is required that food contact
articles "must be sufficient inert to preclude substances from being transferred to food in
quantities large enough to endanger human health or to bring about an unacceptable change in
the composition of the food or a deterioration in its organoleptic properties".
This document stands to certify that all OnRobot SG-x-H materials, intended for food contact
complies with:
1. Europe:
Regulation (EC/EU) No. 1935/2004 and national provisions (Article 6). The materials of SG
Tools are suitable for food contact, materials and articles under article 3 of the before
mentioned egulation. Compliance with the, requirements of Regulation (EC/EU)
No.1935/2004 for the food contact material or article, concerning any limitations in
particular max. use limits or limits on migration or extraction, the effect on taste and
smell of the food and the suitability of the article for the specific use must be in
compliance with the recommendations of the BfR.
See results next page.
2. USA:
FDA 21 CFR 177.2600 "Rubber articles intended for repeated use in contact with food".
Tested and approved for use on non-fatty food objects.
See results next page.
The above product is also produced according to EC regulation 2023/2006 "Good manufacturing
practice for materials and articles intended to come into contact with food" and is subject to
control by the Danish food and health authorities.
To the best knowledge of the manufacturer, that the information presented in this certificate,
is correct as of date of the declaration. It is the responsibility of the end-user to ensure that the
status of the regulation is still in effect at the date of use.
Odense, April 6th, 2020
Group Management
Vilmos
CTO
Beskid
177
Publicité
Table des Matières
