System menu, respectively possible settings
MENU
b) Automatic mode
Rendering of preinstalled device internal chases.
• Select the automatic mode (display AUt0) using the MENU key.
• Press the ENTER key to switch to the submenu.
• Select the desired automatic mode (Pr00-Pr18) with the UP, respectively DOWN key.
• Press the ENTER key.
• Press the UP, respectively the DOWN key to select the desired speed for the program sequence (display
S001-S255).
• Press the ENTER key.
• Press the UP, respectively the DOWN key to select the desired speed for stroboscopic effect (display
FL01-FL04).
28
This selection is possible by the use of the remote control only.
DMX512 address / SLAVE modes
Rendering all chase modes
Chase modes 1~18
Speed setting
Strobe LEDs speed setting (white LEDs)
Rendering all SOUND modes
SOUND modes 1~16
Firmware version
Red LEDs light up
Green LEDs light up
Blue LEDs light up
Amber LEDs light up
Strobe speed colour mode
Device is switched off