Master-Slave Mode; Sound-To-Light Mode; Effect Speed For Sound-To-Light/Automatic Mode/Fade Effects; Manual Colour Setting - Renkforce 1284227 Mode D'emploi

b) Master-Slave Mode
• Set the option NASt in the menu SLNd to define the device as a master (control via the installed
controller).
• Set the option SLAU in the menu SLNd to define the device as a slave (control via the controller of the
connected master device).
If the device is to be operated as a single device (stand alone), it must be defined as a master
device.
Only one device in a master-slave-chain must be defined as master device. All other devices
must be defined as slave devices.
If the device is defined as a slave device, and if no signal is recognised at the DMX IN connection,
the display will show StbY.
c) Sound-to-Light Mode
• Set the SoUn option in the ShNd menu to operate the device in sound-to-light operation.
• Select the desired Sound-to-Light effect under So01-So27.
• The effect light is controlled via an installed microphone in time with the music.
d) Effect Speed for Sound-to-Light/Automatic Mode/Fade Effects
• Set the option SPee in the menu ShNd to set the effect speed.
• Select the desired speed from SP01-SP99 (slow > fast).
e) Manual Colour Setting
• Set the option NAnU in the menu ShNd.
• Set the option oFF/on to on. This switches operation on or off again with manual colour settings.
• Set the brightness of the colours blue, green and red with the options bLue, Gree and red and generate
the desired mixed colour this way.
• Specify the strobe speed for operation with manual colour settings with the option FLAS.
FS 0: no strobe effect
FS 1-FS15: Strobe effect slow > fast
35