Master-Slave Mode; Sound-To-Light Mode - Renkforce 1384778 Mode D'emploi

8-channel DMX operation
DMX channel
1
2
3
4
5
6 (CH8 = 000-059)
6 (CH8 = 060-255)
7 (CH8 = 060-119)
8
c) Master-Slave Mode
• Select the desired operating mode in the menu of the master device.
• Activate the operating mode SLAV on all slave devices.
Only one device in a master-slave-chain must be defined as master device. All other devices
must be defined as slave devices.
d) Sound-to-Light Mode
• Set SOUn in the menu to operate the device in sound-to-light operation.
• Use Sd01-Sd30 to select the trigger sensitivity of the installed microphone.
The effect light is controlled via an installed microphone in time with the music in this mode.
All manuals and user guides at all-guides.com
Value Function
000-255 Brightness red 0-100%
000-255 Brightness green 0-100%
000-255 Brightness blue 0-100%
000-255 Brightness white 0-100%
000-255 Total brightness 0-100%
000-006 No strobe effect
007-065 Strobe speed slow > fast
066-069 Light off
070-128 Pulsing strobe effect slow > fast
129-132 Light off
133-191 Colour strobe with fade-in effect slow > fast
192-195 Light off
196-255 Colour strobe with fade-out effect slow > fast
000-255 Speed setting for channel 8
000 Light off
001-255 Colour selection (channel 8 = 060-119)
000-059 Channel 1-6 activated
060-119 Colour selection via channel 7 / strobe speed via channel 6
120-179 Colour change effect / speed via channel 6
180-239 Fade effect / speed via channel 6
240-255 Sound-to-light effect / reaction sensitivity via channel 6
29