Troubleshooting; Scrapping - Nilfisk SCRUBTEC 234 C Manuel D'utilisation

ENGLISH

TROUBLESHOOTING

Trouble
There is no power supply. The motors do not
turn on.
Dirty water vacuuming is insuffi cient or there is
no vacuuming.
The solution fl ow is insuffi cient.
The brush does not turn.
The squeegee leaves marks on the fl oor.
The fl oor is not suffi ciently cleaned.
(*) This maintenance procedure must be performed by Nilfi sk Alto authorised Service Center.
For further information refer to the Service Manual, available at any Nilfi sk Alto Service Center.

SCRAPPING

Have the machine scrapped by a qualifi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force:
– Brush
– Electrical and electronic components (*)
(*) Refer to the nearest Nilfi sk Alto Center especially when scrapping electrical and electronic components.
14
USER MANUAL
Possible Cause
The power supply cable is faulty or
disconnected from the electrical mains.
There is a faulty switch on the panel.
The squeegees are dirty or the squeegee
blades are worn or damaged.
The vacuum inlet is clogged.
The vacuum hose is disconnected or faulty.
The tank gasket is faulty.
The turbine pre-fi lter is dirty.
The solution fi lter is dirty.
The driving belt is loose or torn.
The brush is not properly installed.
The brush motor is faulty.
There is debris under the squeegee blades.
The squeegee blades are worn, chipped or
torn.
The brush is worn.
The brush is too soft.
The working speed is too fast.
SCRUBTEC 234 C - 9099346000
Remedy
Replace the cable (*) or connect it.
Replace the switch (*).
Clean or replace the squeegees.
Clean.
Clean, connect or replace.
Replace.
Clean.
Clean or replace.
Adjust or replace (*).
Install properly.
Replace (*).
Remove the debris.
Replace the blades.
Replace.
Use a harder brush.
Work at a slowest speed.