Machine Operation (Scrubbing/Drying) - Nilfisk SCRUBTEC 234 C Manuel D'utilisation

ENGLISH

MACHINE OPERATION (SCRUBBING/DRYING)

1. Prepare the machine as shown in the previous paragraph.
2. Clean or vacuum the fl oor to remove any debris.
3. Connect the power supply plug (7) to the electrical mains.
WARNING!
Before connecting the power supply plug to
the electrical mains, check that frequency and
voltage, shown on the machine serial number
plate (26), match the electrical mains voltage.
4. Turn the main switch (2) to "I", to turn on the brush motor.
5. Turn the switch (3) to "I", to turn on the vacuum system
motor.
6. Turn the pump switch (4) to "I", to turn on the solution fl ow
to the brush.
7. Press the pedal (Fig. 3) to lower the brush and squeegees
on the fl oor.
8. While keeping the hands on the handlebar, start the
machine by pressing the brush switches (6) and then start
scrubbing/drying the fl oor.
9. With the switch (5) adjust the solution fl ow according to the
type of cleaning to be performed.
• The switch is not pressed (
be cleaned are not very dirty; in this condition, the
machine autonomy is 10 minutes approximately.
• The switch is pressed (
cleaned are dirty or very dirty; in this condition, the
machine autonomy is 7 minutes approximately.
10. For a better result, the machine must run at a low speed.
11. In case of tough dirt, wash the fl oor thoroughly by turning
the vacuum system switch (3) to "0", then wash the fl oor
again and then collect the liquids by turning the vacuum
system switch (3) to ON.
CAUTION!
To avoid damaging the fl oor surface, do not use
the brush without the solution and, when the
machine is not operating, stop the brush.
12. At the end of the work, release the switches (6), turn
the main switch (2) to "0", then lift the brush and the
squeegees with the pedal (Fig. 4).
10
USER MANUAL
): when the fl oors to
): when the fl oors to be
SCRUBTEC 234 C - 9099346000
Figure 3
Figure 4
P100514
P100515