Machine Operation (Scrubbing/Drying) - Nilfisk BA 410 Manuel D'utilisation

ENGLISH

MACHINE OPERATION (SCRUBBING/DRYING)

1. Start the machine as shown in the previous paragraph.
2. While keeping both hands on the handlebar (2), maneuver the machine and start scrubbing/drying the fl oor.
3. If necessary, vary the solution quantity by using the lever (4).
CAUTION!
To avoid damaging the fl oor surface, do not use the brushes without the solution and, when the machine is not
operating, stop the brush/pad-holder by pressing the switch (65).
CAUTION!
Before lifting the brush/pad, turn it off by pressing the switch (65).
NOTE
For correct scrubbing/drying of fl oors at the sides of the walls, Nilfi sk-Advance suggests to go near the walls with the
right side of the machine as shown in fi gure 3.
Battery discharge during operation
4. Until the green warning light (62) stays on, the batteries allow the machine to work normally. When the green warning light
(62) turns off and the yellow (63) and red (64) warning lights turn on in sequence, it is necessary to charge the battery as the
machine residual autonomy is at the minimum level.
CAUTION!
Do not use the machine with discharged batteries, to avoid damaging the batteries and reducing the battery life.
Machine speed adjustment
5. The machine speed varies according to the type of fl oor to be cleaned and the choice of using the brush or the pad. If
necessary, it is possible to adjust the machine speed, according to the procedure shown in Maintenance chapter.
14
USER MANUAL
A
909 5683 000(2)2007-06 A
Figure 3
BA 410
B
P100160