Before Machine Start-Up - Nilfisk BA 410 Manuel D'utilisation

ENGLISH
Battery installation
6. Disconnect the vacuum hose (22) from the squeegee (11).
7. Disconnect the recovery water drain hose (16) from the
bracket (17).
8. Open the cover (6).
9. Grasp the recovery water tank (A, Fig. 2) in the area (B)
and slightly raise it.
10. Disconnect the vacuum hose (C) from the tank, then
remove the tank (A) with the hoses (D) and (E).
11. Install the batteries on the machine according to the
diagram (28).
12. Install the tank (A, Fig. 2) by performing steps 6 to 10 in
the reverse order.
Battery charging
13. Charge the batteries (see the procedure in the
Maintenance chapter).

BEFORE MACHINE START-UP

Brush or pad-holder installation
NOTE
Use either the brush (54) or the pad-holder (55) according to the type of fl oor to be cleaned.
1. Insert the positioning pin (24) and disengage the machine transport/parking device (23b).
2. Lift the brush/pad-holder deck (10) by prying the handlebar (2).
3. Place the brush (14) or the pad-holder (15) under the deck.
4. Lower the deck (10) by using the handlebar (2).
5. Engage the brush/pad-holder by pressing the brush/pad switch (65) for a few seconds. If the procedure is diffi cult, manually
turn the brush/pad-holder counter-clockwise (58).
Brush/pad application guide (suggestions only)
Types of brushes available
Concrete
Terrazzo fl oor
Ceramic tiles/quarrystones
General cleaning
Marble
Vinyl tiles
Rubber tiles
Rubber tiles
Polishing Marble
Vinyl tiles
Squeegee installation
6. Install the squeegee (11) and fasten it with the handwheels (12), then connect the vacuum hose (22) to the squeegee.
12
USER MANUAL
909 5683 000(2)2007-06 A
A
Midlite Grit 180 Midgrit 240
BA 410
B
C
D
Figure 2
Prolite
E
S310233 A
Union Mix