Introduction; Manual Purpose And Contents; Target; How To Keep This Manual - Nilfisk SCRUBTEC 234 C Manuel D'utilisation

ENGLISH

INTRODUCTION

NOTE
The numbers in brackets refer to the components shown in Machine Description chapter.
Thank you for choosing a Nilfi sk Alto scrubber-dryer.
Nilfi sk Alto Scrubtec 234 C scrubber-dryer is an effi cient and superior quality machine for fl oor cleaning.
The machine is equipped with one cylindrical brush for a cleaning width of 440 mm.
Front and rear squeegees clean out the fl oor, while a vacuum system collects the dirty water, all in one wipe.

MANUAL PURPOSE AND CONTENTS

The purpose of this Manual is to provide the operator with all necessary information to use the machine properly, in a safe and
autonomous way. It contains information about technical data, safety, operation, storage, maintenance, spare parts and disposal.
Before performing any procedure on the machine, the operators and qualifi ed technicians must read this Manual carefully. Contact
Nilfi sk Alto in case of doubts concerning the interpretation of the instructions and for any further information.

TARGET

This Manual is intended for operators and technicians qualifi ed to perform the machine maintenance.
The operators must not perform procedures reserved for qualifi ed technicians. Nilfi sk Alto will not be answerable for damages
coming from the non-observance of this prohibition.

HOW TO KEEP THIS MANUAL

The User Manual must be kept near the machine, inside an adequate case, away from liquids and other substances that can cause
damage to it.

DECLARATION OF CONFORMITY

The Declaration of Conformity, supplied with the machine, certifi es the machine conformity with the law in force.
NOTE
Two copies of the original declaration of conformity are provided together with the machine documentation.

IDENTIFICATION DATA

The machine model and serial number are marked on the plate (26).
Product code and year of production are marked on the same plate.
This information is useful when requiring machine spare parts. Use the following table to write down the machine identifi cation data.
MACHINE model ...............................................................................
PRODUCT code ................................................................................
MACHINE serial number ...................................................................

OTHER REFERENCE MANUALS

– Spare Parts List (supplied with the machine)
– Service Manual (that can be consulted at Nilfi sk Alto Service Centers)

SPARE PARTS AND MAINTENANCE

All necessary operating, maintenance and repair procedures must be performed by qualifi ed personnel or by Nilfi sk Alto Service
Centers. Only original spare parts and accessories must be used.
Contact Nilfi sk Alto for service or to order spare parts and accessories, specifying the machine model, product code and serial
number.

CHANGES AND IMPROVEMENTS

Nilfi sk Alto constantly improves its products and reserves the right to make changes and improvements at its discretion without
being obliged to apply such benefi ts to the machines that were previously sold.
Any change and/or addition of accessories must be approved and performed by Nilfi sk Alto.
2
USER MANUAL
SCRUBTEC 234 C - 9099346000