Tank Emptying; Machine Transport; After Using The Machine - Nilfisk SCRUBTEC 234 C Manuel D'utilisation

TANK EMPTYING

WARNING!
At the end of every cleaning cycle, drain the recovery tank (15) to avoid that the dirty water is ejected from the
tanks (for example during an abrupt machine movement).
The recovery tank (15) is equipped with an automatic shut-off valve (24) to prevent the solution from entering the vacuum system.
When the vacuum fl ow is closed, the recovery tank must be drained. The machine cannot collect water when the valve is closed.
When the recovery tank (15) is full, empty it according to the following procedure:
1. Turn the main switch (2) to "0".
2. Disconnect the plug from the electrical mains.
3. Lift the brush and the squeegees with the pedal (25).
4. Drive the machine to the appointed disposal area.
5. Manually remove the recovery tank and empty it.
6. Then, rinse the recovery tank with clean water.

MACHINE TRANSPORT

1. Roll up the power supply cable to the relevant holder on the handlebar.
2. Unlock the handlebar (8) with the lever (9).
3. Turn the handlebar until the end of stroke, above the machine cover.
4. Lock it.
WARNING!
Do not lift the machine if the handlebar is bent. Transport the machine by lifting it with the specifi ed handgrips
(10) and (11).

AFTER USING THE MACHINE

1. Turn the main switch (2) to "0".
2. Lift the brush and the squeegees with the pedal (25).
3. Disconnect the plug from the electrical mains and roll up
the cable.
4. Drain the solution tank (14) and clean it with clean water.
5. Drain the recovery tank (15) and clean it with clean water.
6. Check the hoses and replace them if necessary.
7. Remove the brush (20) and clean it with clean water.
8. Check the inner channels of the squeegees (18 - 19) and
clean them with clean water.
9. Check the solution fi lter (A, Fig. 5) and pre-fi lter (B). Clean
them with clean water and replace them if necessary.
10. Check the drain fi lter (C). Clean it with air and replace it if
it is clogged.
11. Store the machine in a clean and dry place.
USER MANUAL
SCRUBTEC 234 C - 9099346000
ENGLISH
Figure 5
P100516
11