Table des Matières
Publicité
GB - Instructions for use and maintenance
Cleaning the "duct"
(freestanding version)
To access the "duct" in the "freestanding" version, it
is necessary to lift the whirlpool cover and place it
on the revolving supports.
3 people are required for this task.
1 Grab the inner edge of the cover and positioning
yourself near the feet with the revolving supports
(see figure).
2 Lift the cover.
3 Turn the revolving supports outward with your
foot.
4 Place the cover on the supports.
5 Cleaning the "duct".
1
x3
3
Main errors displayed
on the keyboard
FE-r (filling Error)
A reading error of the level sensors or lack of
water for the automatic replenishment.
The heater is disabled.
Disconnect the power supply by means of the
main switch.
Reconnect the power supply.
FL-o
It indicates the lack of flow when there should
be. This can also be caused by a water level that
is too low in the compensation tanks, which gives
rise to an excessive cloudiness.
The heater is disabled.
Disconnect the power supply by means of the
main switch.
Reconnect the power supply.
FL-c
It indicates the presence of flow when there
should not be.
Disconnect the power supply by means of the
main switch.
Reconnect the power supply.
2
37
Minipool
Publicité
Table des Matières
