Scheppach DP19 Vario Traduction Des Instructions D'origine page 29

Residual risks
The electric tool has been built according to state-
of-the-art and the recognised technical safety
rules. However, individual residual risks can arise
during operation.
• Health hazard due to electrical power, with the use
of improper electrical connection cables.
• Furthermore, despite all precautions having been
met, some non-obvious residual risks may still re-
main.
• Residual risks can be minimised if the "Safety in-
structions" and "Proper use" are observed along
with the whole of the operating instructions.
• Do not load the machine unnecessarily: too much
pressure when drilling quickly damages the tool at-
tachment. This can lead to a reduction in the per-
formance of the machine during machining and a
reduction in accuracy.
• Avoid accidental starting of the machine: the oper-
ating button may not be pressed when inserting the
plug in an outlet.
• Use the tool that is recommended in this manual.
This is how to ensure that your device provides opti-
mum performance.
• Keep your hands away from the work area, when the
machine is in operation.
• Before maintaining or adjusting, switch off the ma-
chine and unplug the power plug.
6. Technical data
Rated input voltage
Nominal power
Motor speed
Output speed
(continuously adjustable)
Chuck adapter
Chuck
Drilling table size
Angle adjustment
Drilling depth
Column diameter
Height
Weight
Laser class
Technical changes reserved!
Noise and vibration
The noise values have been determined in accordance
with EN 62841.
Wear hearing protection.
Excessive noise can result in a loss of hearing. Total
vibration values (vector sum of three directions) deter-
mined according to EN 62841.
Vibration emission value a
Uncertainty K = 1,5 m/s
The specified vibration emission value has been meas-
ured according to a standardised testing procedure
and can be used for comparison of one power tool with
another; and may change depending on the way in
which the power tool is used and in exceptional cases
may be higher than the specified value.
The specified vibration emission value can be used to
230-240V~ 50 Hz
compare one power tool with another.
550 W
The specified vibration emission value can also be
used for an initial estimation of the impair.
1490 min
-1
7.
440 - 2580 min
-1
B16
• Open the packaging and carefully remove the de-
1.5 - 13 mm.
• Remove the packaging material, as well as the pack-
190 x 190 mm
• Check whether the scope of delivery is complete.
45° - 0° - 45°
• Check the device and accessory parts for transport
60 mm
59.5 mm
870 mm
• If possible, keep the packaging until the expiry of the
27 kg
2
www.scheppach.com
Laser wavelength
Power of laser
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
WA
Uncertainty K
WA
h
2
Before commissioning
vice.
aging and transport safety devices (if present).
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
warranty period.
650mm
1mW
73,8 dB(A)
3 dB(A)
86,8 dB(A)
3 dB(A)
1.7 m/s
2
GB | 29