Spare Parts; Taking Out Of Service And Dismantling; Storage; Disposal - Mennekes AMTRON Compact 3,7 / 11 C2 Manuel D'utilisation Et D'installation

9.1

Spare parts

If replacement or accessory parts are necessary for trou-
bleshooting, these must first be checked to ensure the
same design.
f Use only spare parts and accessories that are manu-
factured and / or approved by MENNEKES.
Î "1.1 Service"
10. Taking out of service and
dismantling
The tasks described in this section may only be
carried out by a qualified electrician.
Disconnect the cables
f Open the device.
Î "5.4 Opening the device"
f Disconnect the supply line.
f Route the lines through the membrane screw connec-
tion from the enclosure.
Dismantling the device
f Remove plugs and screws.
f Remove the device from the wall.
f Close the device.
Î "6.4 Closing the device"

11. Storage

Proper storage can positively affect and maintain the
operability of the device.
f Clean the device before storing.
f Store the device in a clean and dry place in its original
or other suitable packaging.
f Observe permissible storage conditions.
Permissible storage conditions
Storage temperature
Average temperature over
24 hours
Relative humidity

12. Disposal

Discard the device and packaging accord-
ing to regulations at the end of the service
life. Comply with the applicable national
statutory regulations and provisions for dis-
posal and environmental protection in the
country of installation. Old devices and bat-
teries must not be disposed of with house-
hold waste.
f Dispose of packaging material in designated collection
containers.
f Dispose of old devices and batteries via your dealer.
-25 °C... + 40 °C
< 35 °C
max. 95 %
(non-condensing)
EN
21