EUROM Polar 120 Manuel D'instructions page 50

You can then use the device normally again but keep an eye on it for the first 30
minutes to ensure there are no further problems. If the device is showing signs of
problems or the overheating recurs, even though there is no obvious assignable
cause, ask your supplier or a recognised electrician to check/repair the unit.
Cleaning and maintenance
Note! Before cleaning or carrying out maintenance work on the air conditioning
unit, always switch off and remove the plug from the socket! Regular cleaning is
vital in order to keep the unit in good working order!
Cleaning the housing
Always remove the plug from the socket before cleaning the housing. Wipe the
cabinet with a clean, soft, lint-free cloth or soft brush. Do not use aggressive
cleaning agents, scouring pads or brushes and no chemical cleaning agents; this
can damage the material. Never use
flammable cleaning agents such as
benzene or methylated spirits. Let
the device dry completely before
using it again.
Never immerse the plug, electric
cable or any part of the appliance in
water or any other liquid. This can
lead to an electric shock!
Cleaning of the filter
Clean the filter every two weeks; air
conditioning with dirty filter does not operate
properly. The filter is located behind the air
intake grid at the back. You can easily open
this grid and remove the filter. Use a vacuum
cleaner or tap the filters lightly to remove
loose dust and dirt. Then rinse the filter clean
in, at most, lukewarm water (not warmer
than 40°C.), potentially with a mild, neutral
cleaning agent. Let the filter dry thoroughly
in the shade before placing it back. Attention!
Never operate the air conditioning without
the filter!
End of season cleaning
If the device is to be stored for a long period, you must take the following
measures!
 Remove the condensed water. Run the unit for a few hours on fan function so
that the unit is completely dry inside.
 Then switch the air conditioning unit off and remove the plug from the socket.
50