EUROM Polar 120 Manuel D'instructions page 48

Ventilation function
 Press the 'Mode' button until the 'Fan' light is shown on the display.
 The display shows 25°C.
 Set the power to low, medium or high with the 'Speed' button.
 The temperature cannot be changed.
Timerfunction
Automatic start:
 First set at which temperature and in which mode (cooling, dehumidifying or
ventilating) you want the air conditioner to start.
 Switch off the air conditioner using the <On/Off> button. Now the air conditioner
is in the stand-by position.
 Press the <Timer> button.
 Using the <Up> and <Down> buttons, set the number of hours after which the
air conditioner has to start (1-24 hours).
 Press the <Timer> button once again. The displays of the air conditioner and the
remote control show the set number of hours.
The air conditioner will automatically start with the entered settings after the
lapsing of the set number of hours.
Automatic stop:
 Press the <Timer> button while the air conditioner is operating.
 Using the <Up> and <Down> buttons, set the number of hours after which the
air conditioner has to stop (1-24 hours).
 Press the <Timer> button once again. The displays of the air conditioner and the
remote control show the set number of hours.
The air conditioner will automatically stop after the lapsing of the set number of
hours.
Swing function
 Press the 'Swing' button, the light on the display lights up.
 The flap on top swings continuously from the top to the bottom.
 By pressing the button again you switch off the function.
 The flap remains in the last position.
Night function
 Press on the 'Mode' button until the 'Cool' light shows on the display.
 Set the required temperature.
 Press the 'Sleep' button, after 1 hour the temperature is reduced by 1°C and
after 2 hours increased by 2°C.
 The device continues operating in this mode.
 By pressing the 'sleep' button again you switch of the function.
LED display
The display shows the configured temperature or the timer settings. The display also
shows the error codes, see further on in this manual.
48