Publicité
Les langues disponibles
Les langues disponibles
Additional comments
When you start the device and opt for a specific function or change function, the
ventilator will work but the compressor will not start immediately: the latter to
protect the internal components. The symbol that belongs to the configured
function blinks on the display, a sign of the 'waiting mode'. This can last 3 to 4
minutes.
In case of prolonged strong cooling, ice accretion can occur on the interior of the
device. You notice this because the device performs less. To solve this you switch
off the device and give it time to defrost.
When the required cooling or heating temperature has been attained, the device
will continue ventilating but the compressor discontinues operating.
Water outlet
During cooling and
dehumidification, the
device extracts water
from the air. This largely
evaporates again, but
possibly. excess water
accumulates in the
water reservoirs. When
full, the compressor and
motor stop automatically
and the "water tank full"
(W.F) light turns on. In
that case, switch off the
air conditioning and
remove the plug from
the socket. You empty
the water reservoirs by
removing both sealing
caps from the top and
bottom water drainage point (see pictures) and draining the reservoirs into a drain
or collecting them in a container or similar. Do not forget to replace the sealing
caps on the drain afterwards! After this you can start using the air conditioning
again.
Safety
The device is fitted with an overheating safeguard that switches the unit off if it
overheats. If this should occur, you must remove the plug from the socket and
leave the equipment to cool for at least 30 minutes. Remove the cause of
overheating - has the device been (partially) covered? Is it too close to a wall or
another obstacle, preventing it sucking in or dispelling sufficient air?
49
Publicité
