Publicité
Les langues disponibles
Les langues disponibles
18.7
Check/lubricate chain-drive (feed)
Check the chain for any damage (cracks, break-outs). The chain can be moved by turning the
friction wheel to view all parts. Lubricate chains with normal machine grease.
18.8
Replacing/turning the cutter insert
The spiral cutter head is suitable for cutter inserts.
If the planing surface is bad, only the damaged or blunt cutter insert needs to be
replaced/turned.
The appropriate dimensions can be found in the technical data.
Danger from cutting edges! Always wear protective gloves when working on the
cutter
head! Injuries to hands due to sharp cutting edges
18.9
Storage
Store the machine in a dry, frost-proof and lockable place when not in use. Disconnect the
machine from the power supply. Make sure that unauthorised persons and especially children do
not have access to the machine.
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil (e.g.
WD40 rust inhibitor).
Improper storage can damage and destroy important components. Only store packed
or already unpacked parts under the intended ambient conditions!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
N O TE
WAR N I N G
1.
Adjust the machine to thickness planing mode
2.
The dust collection hood must be open in order to have
access to the spiral cutter head (1)
3.
Remove wood chips and dust from the heads of the screws
for cutter inserts (2)
4.
Unscrew the screw for cutter inserts with the key for inserts
(3)
5.
Remove the cutter insert (4)
6.
Thoroughly clean the place of the cutter insert on the spiral
cutter head
7.
If the cutter insert will be turned, clean it thoroughly as well
NOTE:
A cutter insert can be turned 3 times (refer to numbers
(5) for help)
8.
Now renew the cutter insert, or turn it over to the next
number
NOTE:
As an aid, it is advisable to always insert a new cutter
insert with the starting point (6) at the same position
9.
Fix the cutter insert with the screw for cutter inserts.
(Recommended minimum tightening torque 4Nm)
N O TE
HOB305PROSMW2_230V | HOB305PROSMW2_400V
spiral
48
Publicité
