Publicité
Les langues disponibles
Les langues disponibles
NOTE:
To transport the machine, you need a forklift truck with the appropriate load capacity and a
fork of at least 1200 mm length. The fork of the truck should be positioned under the machine.
In the installation site proceed as follows:
NOTE:
Do not lift the machine at the work tables, these are not designed to withstand the tensile
load of the machine weight.
ASSEMBLY
15.1
Check scope of delivery
Always note visible transport damages on the delivery note and check the machine immediately
after unpacking for transport damage or missing or damaged parts. Report any damage to the
machine or missing parts immediately to your retailer or freight forwarder.
15.2
Requirements for the place of installation
Choose a suitable place for the machine. Pay attention to the safety requirements and the
dimensions of the machine. The selected location must ensure a suitable connection to the power
supply as well as the possibility of connection to an extraction system. Make sure that the floor can
support the load of the machine. The machine must be levelled simultaneously at all support
points. It is also necessary to guarantee a distance of at least 0.8 m around the machine. In front of
and behind the machine, the necessary distance must be provided for the feeding of long
workpieces.
15.3
Preparation of the surface
The use of paint thinners, gasoline, corrosive chemicals or abrasive cleaners will result
in damage to the surface! Therefore use only mild cleaning agents.
Before you install and commission the machine at the intended location, carefully remove the
anti-corrosion protection and grease residues. This can be done with the usual solvents. Under no
circumstances should you use nitro thinner or other cleaning agents that could attack the
machine's paint.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Transport the machine in its packaging to the
installation site. To manoeuvre the machine in the
packaging, a pallet truck or a forklift with
appropriate lifting power can be used.
• Open the transport packaging
• Remove the transport securing devices (1)
• Place a transport ramp (2) or similar in front of the transport
pallet (3) to make it easier to move down
• Loosen the clamping screws of the moving device (4).
• Gently move the machine (5) off the transport pallet
N O TE
HOB305PROSMW2_230V | HOB305PROSMW2_400V
ASSEMBLY
35
Publicité
